What are the engine fastener torque specs for 2002–2006 MINI Cooper?

For 2002–2006 MINI Cooper: Head Bolts OEM type – M10: 40 ft‑lb + 90°; M8: 28 ft‑lb; Main case bolts M10: 44 ft‑lb; Outside case bolts M8: 26 ft‑lb; Oil squirter bolt: 3 ft‑lb; Rod bolts OEM type: 15 ft‑lb + 90°; Sneed rods: 25 ft‑lb; Cam cap bolts: 13 ft‑lb; Main crankshaft bolt: 85 ft‑lb; Cam gear: 75 ft‑lb; Timing chain tensioner cap: 46 ft‑lb; Timing chain guide bolts: 22 ft‑lb; Oil pump/timing cover to block: M6 = 9 ft‑lb, M8 = 13 ft‑lb.

What are the engine fastener torque specs for 2007–2013 MINI Cooper?

For 2007–2013 MINI Cooper: Head Bolts OEM type – M10: 30 Nm + 90° + 90° with lube; M8: 15 Nm + 90° + 90°; M8 outside of head: 30 Nm; Main Bolts OEM type – M9: 30 Nm + 150°; Outside case bolts: 12 Nm; Oil squirter bolt: 9 Nm; Rod bolts OEM type: 20 Nm + 90°; Sneed rods: 19 ft‑lb; Cam cap bolts: 11 Nm; Main crankshaft bolt: 50 Nm + 180°; Cam gear (non‑VANOS): 20 Nm + 90°; Cam gear (VANOS): 20 Nm + 180°; Timing chain tensioner: 65 Nm; Timing chain guide bolts with gasket: 24 Nm; Timing guide bolt in cylinder head: 20 Nm; Oil pump to block: 25 Nm; Oil pump drive gear: 24 Nm.

SneedSpeed Installation & Torque Specifications Guide

Overview

This guide provides installation instructions, torque specifications, and setup notes for SneedSpeed Performance components.
Each product is precision-engineered for strength, reliability, and ease of assembly — whether your build is for the street, strip, or track.
Following the correct clearances, torque values, and break-in procedures ensures long service life and peak performance.

Please read all instructions before installation. Always use proper tools, clean components, and quality lubricants such as Motul or assembly lube where specified.

Included Instructions

Below are links to each specific instruction and torque specification page included in this guide:

Sneed Forged Pistons – Installation & Clearances
Top/second ring gap, piston-to-wall clearance, assembly tips.
Sneed Forged Connecting Rods – Installation & Torque Specs
Bearing clearances, torque settings, bushing prep, and orientation.
Sneed Race Transmission – Installation & Fluid Guide
LSD setup, fluid type, filling procedure, and readiness notes.
Sneed Performance Engine – Install & Break-In Procedure
Priming, initial startup, test drive break-in, and oil recommendations.
General Torque Specs for 2002–2006 R50–R53
General Torque Specs for 2007–2013 R55–R59

General Notes

Always verify torque specs with a calibrated torque wrench.
Check oil and fluid levels after the first heat cycle.
Use new gaskets, seals, and hardware where applicable.
Retorque fasteners after initial use if noted in product-specific instructions.

– The SneedSpeed Team
? sneedspeed.net
Performance. Precision. Reliability.